Have you recently purchased a new key fob for your 2014 Honda CRV or found yourself with a dead battery in your existing remote? The good news is that programming your Honda CRV key is a straightforward process you can complete yourself at home. Forget about costly dealership visits; this guide will walk you through 9 easy steps to program your 2014 Honda CRV key and regain keyless entry and start functionality.
Step-by-Step Guide to Program Your 2014 Honda CRV Key
Step 1: Gather All Your Remotes.
Before you begin, make sure you have all the remotes you intend to use for your 2014 Honda CRV. The programming session will erase any previously programmed remotes, so you must program all of them at once, even if you are only adding one new key.
Step 2: Get Inside Your Honda CRV.
Enter your 2014 Honda CRV and ensure all doors are closed completely and are unlocked. You will need to be seated inside the vehicle for the programming process to work correctly.
Step 3: Turn the Ignition to the ON Position.
Insert your key into the ignition and turn it to the “ON” position. This is the position just before you would start the engine. You should see the accessory lights and dashboard illuminate.
Step 4: Press the “LOCK” Button.
Within 5 seconds of turning the key to the “ON” position, press and hold the “LOCK” button on one of your Honda CRV remote controls for approximately one second.
Step 5: Turn the Ignition to the OFF Position.
Turn the ignition key back to the “OFF” position, removing your foot from the pedals and ensuring the car is not attempting to start.
Step 6: Repeat the ON/OFF Cycle.
Repeat Steps 4 and 5 two more times. This means you will cycle the ignition from “ON” to “OFF” a total of three times, pressing the “LOCK” button for one second each time while turning it to “ON”. Remember, each step must be completed within 5 seconds of the previous one.
Step 7: Enter Programming Mode.
Turn the key to the “ON” position for the fourth time. Then, immediately press the “LOCK” button on the remote again. If you have successfully entered programming mode, you will hear the door locks cycle, making a distinct “clunk” sound, similar to when you normally lock or unlock your doors using the remote or door switch. This sound confirms that your 2014 Honda CRV is now in Remote Programming Mode and ready to learn the key codes. Do not turn the key off at this stage.
Step 8: Program Additional Remotes (If Applicable).
If you have additional remotes to program for your 2014 Honda CRV, now is the time. Within 5 seconds of hearing the locks cycle in Step 7, press the “LOCK” button on each additional remote, one at a time, for one second each. After each successful remote programming, you should hear the door locks “clunk” again, confirming that each remote has been successfully added to your vehicle’s memory. Note that a 2014 Honda CRV can be programmed with a maximum of 3 remotes. The programming mode will remain active for approximately 10 seconds.
Step 9: Exit Programming Mode and Test.
Finally, turn the ignition key to the “OFF” position and remove it from the ignition. Now, test each of your programmed remotes to ensure they are working correctly. Press the “LOCK” and “UNLOCK” buttons to verify that they control the door locks of your 2014 Honda CRV. Also, test the remote start function if your key fob is equipped with it, ensuring that your newly programmed key can start your car remotely.
Important Reminders:
Keep in mind that your remote key will not operate if the key is left in the ignition. If you have lost your original keyless entry remote for your 2014 Honda CRV, programming a new remote is also a good security measure to prevent unauthorized access to your vehicle. By following these steps, you can easily program your 2014 Honda CRV key and enjoy the convenience of remote keyless entry and start.
