How to Program Your 1997 Acura TL Key Fob: A Step-by-Step Guide

Experiencing issues with your 1997 Acura TL key fob? Don’t worry, reprogramming it might be simpler than you think. This guide provides clear, easy-to-follow instructions on how to program your key fob for 1996-1998 Acura TL models equipped with a factory-installed security system. Get your remote working again quickly with these straightforward steps.

Programming Your 1997-1998 Acura TL Transmitter

Follow these instructions to program your Acura TL key fob. This process will erase all previously programmed transmitters, so ensure you have all the remotes you intend to use ready to program.

  1. Open the Driver’s Door: Begin by opening the driver’s side door of your 1997 Acura TL.

  2. Unlock and Hold: Locate the master power door lock switch on the driver’s door. Push it to the ‘UNLOCK’ position and hold it there throughout the entire programming procedure.

  3. Key Insertion Cycle: Insert the ignition key into the ignition switch, and then remove it. Repeat this insert and remove action four more times, completing a total of five cycles within a 10-second timeframe. Speed is important here; ensure you perform these steps promptly.

  4. Enter Programming Mode: Insert the key into the ignition switch one last time. Watch for the power door locks to cycle. This cycling action indicates that your Acura TL’s system has successfully entered the key programming mode.

  5. Program Transmitter 1: Press either the “LOCK” or “UNLOCK” button on the first key fob transmitter you wish to program. Observe the power door locks (all except the driver’s door) cycle once more. This cycle confirms that the system has accepted the transmitter code.

  6. Program Second Transmitter (Optional): If you have a second key fob to program, press the “LOCK” or “UNLOCK” button on this transmitter within 10 seconds of programming the first one. Again, the power door locks should cycle to confirm acceptance. Remember, the system can learn up to two transmitters.

  7. Exit Programming Mode: Release the master power door lock switch that you’ve been holding in the ‘UNLOCK’ position. This action will exit the programming mode.

Important Programming Notes:

  • Two Transmitter Limit: The Acura TL system can only store programming for a maximum of two key fobs.
  • Memory Reset: Entering programming mode will erase all previously learned transmitter codes. Therefore, you MUST reprogram ALL transmitters you intend to use during a single programming session.
  • Timing is Crucial: Steps 3 and 4, the key insertion and removal cycle, must be completed within 10 seconds to successfully enter the programming mode. If you exceed this time, you may need to start the procedure again.

Ordering a Replacement Transmitter for Your Acura TL

Should you require a replacement key fob transmitter for your 1997 Acura TL, these can only be ordered through authorized Acura dealerships. Acura dealers order transmitters from American Honda using their standard parts ordering procedures. Contact your local Acura dealer to order a new transmitter.

Battery Information for the Acura TL Key Fob

The battery required for the 1997 Acura TL key fob transmitter is a CR2016. Each transmitter unit utilizes two CR2016 batteries. When replacing the battery, ensure you are using the correct type and follow proper battery installation procedures, typically indicated inside the transmitter casing.

Conclusion

Programming your 1997 Acura TL key fob is a straightforward process that can be completed at home by following these steps. By carefully adhering to these instructions, you can quickly restore the functionality of your keyless entry system. If you encounter any difficulties or the programming is unsuccessful, it is recommended to consult with an authorized Acura dealer for further assistance.

Comments

No comments yet. Why don’t you start the discussion?

Leave a Reply

Your email address will not be published. Required fields are marked *