Have you recently purchased a new keyless entry remote fob for your Honda, or perhaps the battery in your existing remote has died? The good news is, programming your Honda key fob is a straightforward process you can easily accomplish yourself. Forget the dealership visit and the associated costs; this guide provides a simple, step-by-step method to program your Honda remote in just minutes.
Step-by-Step Guide for Programming Your Honda Key Fob
This process is designed to be user-friendly, allowing you to quickly get your key fob working. Follow these nine simple steps to program your Honda key fob:
Step 1: Gather All Remotes. Before you begin, make sure you have all the key fobs you intend to use with your Honda. Even if you are only programming one new remote, all remotes you want to work with your car must be programmed in the same session. The system will effectively “forget” any previously programmed remotes if they are not included in the current programming session.
Step 2: Get Inside Your Honda. Enter your Honda and ensure all doors are completely closed and unlocked. This is crucial for the programming sequence to initiate correctly.
Step 3: Turn the Ignition to the “ON” Position. Insert your key into the ignition and turn it to the “ON” position. This is the position right before you would start the engine. You should see the accessory lights illuminate and the dashboard lights come on.
Step 4: Press the “LOCK” Button (Within 5 Seconds). Within five seconds of turning the key to the “ON” position, press the “LOCK” button on your remote control transmitter for approximately one second. Timing is important in this step.
Step 5: Turn the Ignition to the “OFF” Position. Turn the ignition key back to the “OFF” position. Do not remove the key from the ignition.
Step 6: Repeat Steps 4 & 5 Two More Times. Repeat the sequence of pressing the “LOCK” button (Step 4) and turning the key to the “OFF” position (Step 5) two more times. This means you will complete a total of three ON/OFF cycles. Remember, each step must be performed within five seconds of the previous one to maintain the programming sequence.
Step 7: Turn the Ignition “ON” Again and Press “LOCK”. Turn the key back to the “ON” position for the fourth time. Then, press the “LOCK” button on your remote one more time. If you have successfully entered programming mode, you will hear the door locks make a distinct “clunk” noise, similar to when you lock or unlock your doors normally. It’s important to note that the doors are not actually locking at this point; this sound simply indicates that your Honda has entered Remote Programming Mode. Leave the key in the “ON” position.
Step 8: Program Additional Remotes (Optional). If you have additional remotes to program, now is the time. Within 5 seconds of the “clunk” noise, press the “LOCK” button on each additional remote you want to program for one second each. You will hear the “clunk” sound again after each remote is successfully programmed, confirming it has been added to the system’s memory. Honda systems typically allow up to three remotes to be programmed. Programming mode will remain active for approximately 10 seconds, giving you time to program multiple fobs.
Step 9: Turn the Ignition “OFF” and Test. Finally, turn the ignition key to the “OFF” position and remove it from the ignition. Now, test each of your programmed remotes to ensure they are working correctly. Try locking and unlocking the doors, and if your remote has other functions like a panic button or trunk release, test those as well.
Keep in mind that your remote will not operate if the key is in the ignition. If you have lost a keyless entry remote, reprogramming your Honda remote system is a smart security measure to protect your vehicle from potential theft. By following these steps, you can easily program your Honda key fob and regain full remote access to your vehicle.
