Programming your car’s built-in garage door opener system, like Car2U®, can seem daunting, but it’s actually a straightforward process. This guide will walk you through programming your Car2U system to work with your Genie garage door opener, ensuring you can conveniently access your garage with just the touch of a button. Whether you have a newer or older Genie model, we’ve got you covered with easy-to-follow instructions.
Programming Car2U for Newer Genie Garage Door Openers (After November 2011)
If your Genie garage door opener was manufactured after November 2011 (serial number starting with 11291 or higher), follow these steps to program your Car2U system:
-
Initiate Programming Mode: Locate the program button on your Genie garage door opener’s powerhead. Press and hold this button until a round blue LED illuminates. Once you see the blue LED, release the program button. A long LED will then start flashing purple, indicating it’s in programming mode.
-
Sync with Car2U Button: Now, inside your car, press and hold the Car2U button you wish to program for one second, and then release it. Press the same Car2U button again for one second and release. You should observe the round LED and the long LED on the garage door opener both turn blue momentarily before switching off. This indicates successful synchronization.
-
Test Your Connection: To confirm the programming was successful, press the programmed Car2U button once more. Your garage door should now activate, opening or closing as expected.
Image showing the location of the serial number on a Genie garage door opener powerhead, used to identify manufacturing date for Car2U programming.
Note: If you’re having trouble finding the program button on your garage door opener’s powerhead, consult the user manual for your specific Genie model for detailed instructions and diagrams.
Programming Car2U for Older Genie Garage Door Openers (Before November 2011)
For Genie garage door openers manufactured before November 2011 (serial number starting with 11290 or lower), the programming steps are slightly different:
-
Enter Programming Mode: Press and hold the program button on your Genie powerhead until both a round blue LED and a long blue LED illuminate simultaneously. Release the program button once both LEDs are lit. The round blue LED will remain on.
-
Prepare for Synchronization: Press the program button on the Genie powerhead one more time. The long purple LED will begin to flash, signaling that the system is ready to learn the Car2U signal.
-
Pair with Car2U Button: Inside your vehicle, press your desired Car2U button for one second and release. Then, press the same Car2U button again for one second and release. The long LED on the garage door opener should flash blue and then turn off, indicating successful pairing.
-
Final Test: Press the programmed Car2U button again to operate your garage door. If the door moves, your Car2U system is now successfully programmed to your older Genie garage door opener.
Note: Always refer to your Genie garage door opener’s user manual if you encounter any difficulties locating the program button or during any step of the programming process. The manual provides model-specific information that can be incredibly helpful.
By following these steps, you can easily program your Car2U system to your Genie garage door opener, regardless of its manufacturing date. Enjoy the convenience of one-touch garage access!
