The Compustar 2WT11R-SS is a sophisticated 2-way replacement remote known for its extended 3-mile range and reliable Digital Spread Spectrum (DSS) technology. This remote not only allows you to remotely start and control your vehicle but also provides instant visual and audible confirmation on its LCD screen. However, to fully utilize these features, you’ll need to program the remote to your specific vehicle. This guide will walk you through the general steps on How To Program Compustar Remote 2wt11r_ss To Car.
Understanding the Programming Process
Before you begin, it’s crucial to understand that programming a Compustar remote, especially for modern vehicles, can be complex. Many vehicles require an additional ignition bypass module, and a solid understanding of vehicle wiring is often necessary. While this guide provides general steps, professional installation is strongly recommended to avoid damaging your vehicle’s electrical system. Always consult your vehicle’s manual and the Compustar owner’s manual for specific instructions.
The programming process typically involves accessing your vehicle’s programming mode, often through a combination of key and ignition cycling, and then pressing specific buttons on your remote to synchronize it with your car’s security system. The exact steps can vary depending on your vehicle’s make, model, and the specific Compustar system installed.
General Steps to Program Your Compustar 2WT11R-SS Remote
While specific steps can differ, here’s a general outline of how to program your Compustar 2WT11R-SS remote. Always refer to your Compustar system’s installation manual for the precise procedure for your vehicle and system.
-
Enter Programming Mode: Typically, this involves turning your vehicle’s ignition key to the “ON” position, then “OFF” a specific number of times in quick succession. The number of cycles can vary (e.g., three times on, three times off). Listen for a chirp or visual cue from your vehicle’s parking lights, indicating you’ve successfully entered programming mode.
-
Press the Programming Button: Locate the programming button on your Compustar control module. This is usually a small, recessed button. Press and release this button once.
-
Activate the Remote: Immediately after pressing the programming button on the module, press and hold the LOCK button on your 2WT11R-SS remote until you hear a chirp or see a light flash from your vehicle. This indicates that the remote’s signal has been recognized.
-
Test the Remote: Exit programming mode (usually by turning the ignition off). Test all the remote functions – lock, unlock, remote start, and trunk release – to ensure the programming was successful.
-
Repeat if Necessary: If the remote doesn’t program correctly the first time, repeat these steps. Sometimes, timing is crucial in the programming process.
Important Considerations
- Professional Help: If you are uncomfortable with these steps or encounter difficulties, seek professional help from a qualified car audio installer or Compustar dealer.
- Vehicle Compatibility: Ensure that the 2WT11R-SS remote is compatible with your specific Compustar control module. Refer to the compatibility information provided with your system.
- Manual is Key: Always consult your Compustar system’s installation manual for the most accurate and vehicle-specific programming instructions.
Programming your Compustar 2WT11R-SS remote can significantly enhance your vehicle’s convenience and security. By following these general steps and consulting your specific manuals, you can attempt to program your remote. However, remember that professional installation is often the safest and most reliable route, especially for complex modern vehicles.
